Lab Objectives:

  • Learn to solder
  • Get your project off the breadboard

Tasks:

  1. Choose a circuit that you made already in this class (from lab 1 or 2). Draw the schematic for that circuit, then transfer the components from the breadboard to a small piece of protoboard.
  2. Solder your components to the protoboard and figure out a way to power your circuit
    (pro tip: don’t use components for this lab that you will miss being able to prototype with…)

Lab 3 Resources:

Blog Response:

  • Post the following photos of what you made: a schematic drawing, progress photos, and your final soldered board. Is there anything you struggled with in this lab?

Lab 3 is due before class on Thursday September 8th. Submit a link to your blog post on Edmodo.